Statistical optimization of operating parameters of microbial electrolysis cell treating dairy industry wastewater using quadratic model to enhance energy generation

The performance of Microbial electrolysis cell (MEC) is affected by several operating conditions. Therefore, in the present study, an optimization study was done to determine the working efficiency of MEC in terms of COD (chemical oxygen demand) removal, hydrogen and current generation. Optimization was carried out using a quadratic mathematical model of response surface methodology (RSM). Thirteen sets of experimental runs were performed to optimize the applied voltage and hydraulic retention time (HRT) of single chambered batch fed MEC operated with dairy industry wastewater. The operating conditions (i.e) an applied voltage of 0.8 V and HRT of 2 days that showed a maximum COD removal response was chosen for further studies. The MEC operated at optimized condition (HRT- 2 days and applied voltage- 0.8 V) showed a COD removal efficiency of 95 ± 2%, hydrogen generation of 32 ± 5 mL/L/d, Power density of 152 mW/cm² and current generation of 19 mA. The results of the study implied that RSM, with its high degree of accuracy can be a reliable tool for optimizing the process of wastewater treatment. Also, dairy industry wastewater can be considered to be a potential source to generate hydrogen and energy through MEC at short HRT.     

Improvement of gaseous bioenergy production from spent coffee grounds Co-digestion with pulp wastewater by physical/chemical pretreatments

Two steps of hydrolysis and anaerobic biogas production processes was investigated in this study. In the first step, subcritical water (SBW) hydrolysis and chemical (acid/alkali) pretreatments were carried out to enhance hydrolysis efficiency by obtaining and analyzing the total volatile fatty acids (TVFA), chemical oxygen demand (COD), and total sugar productions from spent coffee grounds (SCG) hydrolysate. The subcritical water (SBW) hydrolysis under the condition of temperature 150 °C for 30 min can greatly improve the organic matter breakdown and reached the COD concentration of 1010 g/L which was 30% higher than the untreated raw SCG. For chemical pretreatments, it was found that the alkaline hydrolysis of SCG resulted in the greatest total sugar concentration of 181 g/L whereas the operation conditions were 2.0 M NaOH at 60 °C for 1 h. The peak of TVFA concentration 3725 mg/L was found at the acid hydrolysis of SCG with 1.0 M H₂SO₄ acid, 60 °C for 1 h. The optimal biomethane yield of 115 mL/g COD was obtained when 1.0 M H₂SO₄ acid hydrolysate co-digestion with pulp wastewater which increase methane yield production 8 times of raw pulp wastewater. The pretreatment process was confirmed in this study can significant improve the converting of the biowastes to bioenergy efficiency.     

臭氧氧化-循环喷淋法处理钨钼选矿废水

采用臭氧氧化-循环喷淋法去除钨钼选矿废水中COD,研究了pH值、臭氧流量、循环频率对COD去除效果的影响。结果表明: 废水COD去除率随pH值、臭氧流量、循环频率增大而增加,在pH值为10、臭氧流量3.0 L/min、循环频率4.0次/min条件下,氧化120 min后废水COD含量由131 mg/L降至11.5 mg/L,COD去除率达91.2%,满足《污水综合排放标准》(GB 8978-1996)一级标准。与O₂、NaClO处理废水COD的对比试验结果表明,循环喷淋法结合O₃表现出较好的COD去除效果。     

载铜树脂处理高含盐氨氮废水的性能

针对高含盐氨氮废水，选择具有不同功能基团的树脂为载体，进行负载Cu2+改性制得载铜树脂并对其处理高含盐氨氮废水的性能进行研究。在筛选出最佳载铜树脂的基础上，研究pH及Na+浓度、树脂投加量、反应时间对载铜树脂处理高含盐氨氮废水效果的影响，通过对吸附氨氮前后的载铜树脂进行SEM和EDS表征分析并构建吸附动力学模型以进一步探究配位吸附的过程。结果表明，Cu2+可与螯合树脂D751稳定结合且在宽pH值下均表现出耐盐性和良好的氨氮吸附效果；在室温(25℃)、pH=11及Na+浓度4 g/L、树脂投加量8 g/L、反应时间60 min的条件下，D751载铜树脂对氨氮的去除率为34.8%。D751载铜树脂吸附氨氮后其表面出现明显的晶状结构物质，该物质可能为铜氨络合物。D751载铜树脂对高含盐氨氮的吸附符合准二级动力学模型。     

离子交换水软化技术研究与应用进展

离子交换法是目前最常见的水软化技术之一，其基于可逆的离子交换反应将溶液中的硬度离子选择性去除，属于典型的特种分离过程。本文介绍并总结了离子交换水软化的基本原理、水软化用离子交换树脂的结构和分类、离子交换水软化技术研究和应用，并针对离子交换水软化存在的问题提出了相应的解决思路。     

A small-scale silica gel-water adsorption system for domestic air conditioning and water heating by the recovery of solar energy

A small-scale silica gel-water adsorption system with modular adsorber, which utilizes solar energy to achieve the cogeneration of domestic air conditioning and water heating effect, is proposed and investigated in this paper. A heat recovery process between two adsorbers and a mass recovery process between two evaporators are adopted to improve the overall cooling and heating performance. First, the adsorption system is tested under different modes (different mass recovery, heat recovery, and cogeneration time) to determine the optimal operating conditions. Then, the cogeneration performance of domestic cooling and water heating effect is studied at different heat transfer fluid temperatures. The results show that the optimal time for cogeneration, mass recovery, and heat recovery are 600 s, 40 s, and 40 s, respectively. When the inlet temperature of hot water is around 85°C, the largest cooling power and heating power are 8.25 kW and 21.94 kW, respectively. Under the condition of cooling water temperature of 35°C, the obtained maximum COP_c, COP_h, and SCP of the system are 0.59, 1.39, and 184.5 W/kg, respectively.     

浅谈城市废水水质检测方法与应用

国家与地区的经济发展水平一定离不开工业的发展,我国作为工业大国,工业发展对于国家整体经济有着不可取代的作用。然而随着工业的发展,全球性的环境污染和生态破坏越来越严重。特别是我国经济正处于快速发展阶段,城市化进程不断推进,城市污染情况日益严重,城市污水治理工作逐渐被大众所关注,逐渐开始进入公众可能给事业。我国二十世纪七十年代开始逐渐开始现代城市污水的治理工作。因此,对城市污水的水质监测工作成为了极为重要的一个环节。从城市污水检测方式这一角度进行研究,分析当前城市污水水质检验方法提升实际效果的应用模式,希望能够更好的处理我国城市日益严峻废水处理问题。     

Optimization of culture conditions for biohydrogen production from sago wastewater by Enterobacter aerogenes using Response Surface Methodology

Sago wastewater (SWW) causes pollution to the environment due to its high organic content. Annually, about 2.5 million tons of SWW is produced in Malaysia. In this study, the potential of SWW as a substrate for biohydrogen production by Enterobacter aerogenes (E. aerogenes) was evaluated. Response Surface Methodology (RSM) was employed to find the optimum conditions. From preliminary optimization, it was found that the most significant factors were yeast extract, temperature, and inoculum size. According to Face Centered Central Composite Design (FCCCD), the maximum hydrogen concentration and yield were 630.67 μmol/L and 7.42 mmol H₂/mol glucose, respectively, which is obtained from the sample supplemented with 4.8 g/L yeast extract concentration, 5% inoculum, and incubated at the temperature of 31 °C. Cumulative hydrogen production curve fitted by the modified Gompertz equation suggested that H_max, R_max, and λ from this study were 15.10 mL, 2.18 mL/h, and 9.84 h, respectively.